Andis ORL Instrucciones De Uso Y Cuidado página 3

17. WARNING: During use, do not place or leave appliance
where it may be 1) damaged by an animal or 2) exposed
to the weather.
SAVE THESE INSTRUCTIONS
THIS PRODUCT INTENDED FOR PROFESSIONAL USE
OPERATING INSTRUCTIONS
CHARGING TRIMMER USING CHARGING STAND
The AC adapter is intended for use with Andis model ORL lithium-ion trimmer
battery with a rated capacity of 4.5V
from the carton. Plug the AC adapter into a 120V AC outlet, or according to your
local power standards. Plug the adapter cord into the receptable on the back of the
charging stand (Figure A). Place trimmer in the charging stand. The ON/OFF switch
on the trimmer must be in the OFF position for the battery to charge. The blue
light on the trimmer will fade in and out while charging. Note that the trimmer can
be removed at any time during the charging cycle without harming the trimmer or
battery. Once the battery is fully charged, the light on the trimmer (Figure B) will
turn solid blue.
The trimmer has not been charged at the factory. Please charge the trimmer
for 2 hours before the first use for maximum performance.
You can keep the trimmer plugged into the charging stand or adapter when not
in use. The charging stand or adapter will maintain the battery at full charge.
We recommend that the charging stand or adapter be unplugged if the trimmer
won't be used for seven or more days.
FAILURE TO CHARGE
1. Make sure voltage is present at the wall outlet (confirm with an appliance you
know is working).
2. Make sure on/off switch on the trimmer is OFF.
3. Check to make sure adapter cord is plugged firmly into trimmer or charging
stand. Twist the adapter cord slightly to ensure good electrical connection.
4. If failure to charge still exists, return trimmer to Andis or an Andis authorized
service station for examination and repair or replacement.
CORDED OPERATION
If the trimmer powers OFF in the middle of a trimming job, the power cord can be
attached to continue use in corded operation. Plug the adapter cord directly into
the bottom of the trimmer (Figure C). When the trimmer is running with the adapter
cord attached, the blue light will remain solid ON to indicate strong power, even if
the battery is not fully charged. The trimmer will charge at a slower rate while in
use with the cord attached.
4
1.2A. Remove the trimmer and AC adapter
A B
D E
H
G
J K
C
LIGHT BOTTOM OF TRIMMER
F
I
OIL
BLADE
SCREWS
ATTACHMENT
SCREW
L
5