Publicidad
Idiomas disponibles
Idiomas disponibles
1. Remove lower fascia – use T20, T30 driver to remove (4) screws at bottom fascia and (3)
screws inside wheel well (each side), as shown in Figure 2.
4. Feed the carriage bolt ① and spacer ② through frame rails opening using the pull wires ⑤.
Pull the wires through slots on the bracket first and then holes on frame rails, as shown in
Figure 4. Remove pull wires and loosely install conical washer ③ and hex nut ④ to the hitch.
5. Tighten all 7/16'' GR5 fasteners with torque wrench to 50 Lb.-Ft. (68 N*M)
Proper torque is needed to keep the hitch secure to the vehicle when towing.
©2015 Cequent™ Performance Products, Inc. - Printed in Mexico
2. Remove bumper – use 13mm socket to remove (2) screws on driver side and (4) screws on
passenger side. Return bumper and screws to customer.
3. Raise the hitch into position and insert the brackets into frame rails opening, as shown in Figure 3.
6. Locate center line of lower fascia and trim 3.5'' tall and 3.5'' wide area, beginning from slot
opening in fascia as shown in Figure 5.
7.Reinstall the screws and fascia removed in Step 1. Double check if the trim area is enough
to avoid interference between fascia and hitch. Make additional trimming if needed.
3.5''
3.5''
Sheet 4 of 12
75218NP
CEQUENT
05-15-15
Rev. A
Publicidad
