Aquatic 1177 Información De Instalación página 4

6
Level back wall vertically & horizontally.
Shim if necessary.
8A
Install drain assembly per manufacturer's instructions. Spread
foundation material (see Diagram 8A for center drain units and
Diagram 8B for end drain units). NOTE: Use of foundation materials
is highly recommended for firmer bottom support.
9
Place base into framing pocket.
Aquatic • 8101 E. Kaiser Blvd. • Anaheim, CA 92808 • (800) 877-2005 • FAX (714) 998-5340 • www.aquaticbath.com
Installation Data
7
Remove back wall and base.
8B
When using foundation materials, the following applies: Mix
foundation material. Place three or four mounds of plaster on the
subfloor around but away from drain hole. The mounds should be
placed high enough so that when the unit is set, it will cause the
plaster to displace and spread.
10
Tap down until level. Level lengthwise and widthwise using 3 ft.
(915mm) level by shimming or depressing foundation materials. The
unit should be set level.
— 4 —
4-Piece Low-Threshold Showers
Fax on Demand # 1177