Aquatic 1177 Información De Instalación página 6

17
Pre-drill and fasten left wall. Pre-drill horizontal nailing flanges along
top of left side wall and fasten into each corresponding stud. Pre-drill
side (vertical) nailing flange and fasten to side studs 8" (200mm)
on center.
19
Pre-drill and fasten right wall. Pre-drill horizontal nailing flanges
along top of right side wall and fasten into each corresponding
stud. Pre-drill side (vertical) nailing flange and fasten to side studs
8" (200mm) on center.
21
Aquatic • 8101 E. Kaiser Blvd. • Anaheim, CA 92808 • (800) 877-2005 • FAX (714) 998-5340 • www.aquaticbath.com
Installation Data
18
Silicone front edge, located approximately 4" (100mm) from the
front of the unit.
20
Refer to "Tub and Shower Mounted Fitting" for measurements. Using
a hole saw (fine tooth or abrasive grit cutting edge), make necessary
openings for filler and valves, drilling from inside (smooth side) out.
Clean unit. Apply a strip of painter's masking tape along the inside
edge of each side of the seam where silicone sealant will be applied.
Apply silicone to the joints/seams and smooth over with finger or
caulking tool. While the silicone is still wet, remove tape strips along
joint edges. NOTE: Allow silicone to cure for 24 hours (normal cure
time) before using bath or shower. Humidity affects the curing process
and different geographical areas experience varying degrees of
humidity. Refer to silicone manufacturer's instructions for additional
information related to curing times.
— 6 —
4-Piece Low-Threshold Showers
Fax on Demand # 1177