Imetec L4602 Instrucciones Para El Uso página 11

• DO NOT pull or lift the appliance by the supply cord.
• DO NOT expose the appliance to humidity or atmosferic agents
(rain, sun, etc.) or extreme temperatures.
• Always disconnect the appliance from the mains supply before cleaning
or performing maintenance and when the appliance is not in use.
• If the appliance is faulty or malfunctions, switch it off and do not tamper
with it. Contact an authorised technical service centre for any repairs.
• If the supply cord is damaged it must be replaced by an authorised
technical service centre, so as to prevent all risks.
• When the appliance is used in a bathroom, unplug it after use since
the proximity of water presents a hazard even when the appliance is
switched off.
• For additional protection, the installation of a residual current device
(RCD) having a rated residual operating current not exceeding 30 mA
(ideal 10 mA) is advisable in the electrical circuit supplying the bathroom.
Ask your installer for advice.
• This appliance must not come into contact with water, other liquids,
spray or steam. For cleaning and maintenance, refer exclusively to the
relative paragraph herein.
• DO NOT use this heater in the immediate surroundings of a bath, a
shower or a swimming pool. DO NOT use this appliance near a washbasin
full of water. During use the appliance must be placed in such a way that
it cannot fall in the washbasin.
• This appliance must not be located immediately below a socketoutlet.
• Use this heater on a horizontal and stable surface, or fix to the wall, as
applicable.
WARNING! In order to avoid overheating, do not cover the heater.
WARNING! To reduce the risk of fire, keep textiles, curtains, or any
other flammable material at a minimum distance of 1 m from the
air outlet.
WARNING! DO NOT use this heater in small rooms when they are
occupied by persons not capable of leaving the room on their own,
unless constant supervision is provided.
EN
9