Fellowes Orion 500 Manual De Instrucciones página 6

CORRECTING A BOUND DOCUMENT
Additional sheets may be added or removed at any time by opening and then closing the comb as previously described.
REMOVAL OF WASTE CLIPPINGS
The tray should be emptied after every 50 operations to ensure no blockages occur.
TROUBLESHOOTING
Problem
Punched holes are not central
Machine will not punch
Punch holes are not parallel to
edge
Partial holes
Missing holes
Damaged hole edges
Cause
Edge guide not set
Blockage
Debris is stuck below dies
Sheets not correctly aligned to punch
pattern
Selectable dies are not selected to punch
Possibly overloading the machine
Solution
Adjust edge guide until hole pattern is correct
Check waste tray is empty. Check for blockage to paper
entry
Take stiff cardboard and slide into the paper entry. Move
the cardboard sideways to release any stray clippings into
the waste tray
Adjust edge guide and test punch scrap sheets until correct
Check the current dies are selected to punch holes. To
select a die, push selector switch down at the front
Punch plastic covers with paper sheets. Reduce number of
sheets being punched
6