Napa CARLYLE TOOLS 791-9002 Manual Del Funcionamiento página 3

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

SETUP
1. Insert the rear handle (#2) in the front handle (#6) and secure with the hardware provided.
2. Secure the front handle (#6) to the base frame (#12) making sure the stop wheels (#9) are included in the assembly and tighten with the
hardware provided.
3. Install the rollers in the appropriate holes in the base frame (#12) and secure them in place with the snap pins (#17).
4. Install the wheels (#9 and #15) in the base frame (#12) as shown in the exploded view parts drawing on page 4 and secure them with the
hardware provided.
OPERATING INSTRUCTIONS
This is the safety alert symbol used for the OPERATING INSTRUCTIONS section of this manual to alert you to potential personal
injury hazards. Obey all instructions to avoid possible injury or death.
IMPORTANT: Before attempting to raise any vehicle, check vehicle service manual for recommended lifting surfaces.
REMOVAL:
1. Make sure the tire is raised off the ground at a suitable clearance height to accept the wheel dolly's lift rollers. It may be necessary to
loosen the lug nuts that secure the wheel to the wheel hub before raising the tire/wheel off the ground.
2. Support the axle of the lifted wheel with adequate means before removal or installation,
3. Remove lug nuts that secure the tire/wheel combination to the vehicle's wheel hub.
4. Install the lift rollers in the holes of the dolly that are suitable for handling the applicable tire diameter size and secure the rollers in the dolly
with the lock pins provided.
5. Roll the dolly under the tire so the two lift rollers straddle the circumference of the tire and the tire's side wall touches the dolly's stop wheel.
6. Tilt the dolly's handle down just enough for the wheel's lug holes to clear the drum's lug bolts. Use one hand to support the top of tire and
the other hand on the dolly's handle, and pull the loaded dolly away from the wheel drum.
INSTALLATION:
1. Roll the tire/wheel combination onto the dolly's lift rollers and make sure the tire's side wall is up against the dolly's stop wheel. Support the
top of the tire with one hand and use the other hand to tilt the dolly's handle down enough to roll the loaded dolly towards the wheel hub.
2. Align the wheel's lug holes with the hub's lug bolts by slightly rotating the tire. Raise or lower the tire by manipulating the dolly's handle and
push the dolly in towards the hub until the wheel is supported by the hub lug bolts.
3. Thread one lug nut on the top lug bolt to temporarily hold the tire/wheel on the hub and back the dolly away from the hub.
4. Thread the remaining lug nuts on the lug bolts and tighten to the required torque rating.
OWNER/USER RESPONSIBILITY
The owner and/or user must have an understanding of the manufacturer's operating instructions and warnings before using this jack.
Personnel involved in the use and operation of equipment shall be careful, competent, trained, and qualified in the safe operation of the
equipment and its proper use when servicing motor vehicles and their components. Warning information should be emphasized and
understood. If the operator is not fluent in English, the manufacturer's instructions and warning shall be read to and discussed with the
operator in the operator's native language by the purchaser/owner, making sure that the operator comprehends its contents. Owner and/or
user must study and maintain for future reference the manufacturers' instructions. Owner and/or user is responsible for keeping all warning
labels and instruction manuals legible and intact. Replacement labels and literature are available from the manufacturer.
WARRANTY
Please contact your local NAPA Auto Parts Store for details on warranty.
791-9002
OPERATING MANUAL FOR 791-9002
3
08/22/18

Publicidad

Tabla de contenido
loading

Tabla de contenido