SOUNDMASTER SCD2000 Manual Del Usuario página 7

CD Operation
1. Set the FUNCTION switch to the CD/AUX position.
2. Insert the CD disc in the CD compartment and close the CD door, the unit will start reading
the disc, the LED display will show the total number of tracks of the entire disc after reading.
3. To start playing the CD, press the PLAY/PAUSE button.
4. Adjust the VOLUME Control to the desired volume level.
5. To stop playing the CD, press the STOP button.
Skip Mode
1. During play or pause mode, press the SKIP UP button to go to the next track.
2. During play or pause mode, press the SKIP DN button to go back to the beginning of the
track.
3. During play mode, press the SKIP DN button twice will go back to the previous track.
Programming the CD Player
The programming of the CD player should be done during STOP mode.
1. Press the PROGRAM button, the LED display will show ' 01 ' and flash continuously.
2. Press the SKIP UP or SKIP DN buttons to select the desired track.
3. Press the PROGRAM button again to store this track in memory, the LED will show ' 02 ' and
flash continuously.
4. Repeat steps from 2 to 3 to store more tracks in memory. You can store up to 20 tracks in the
memory.
5. Press the PLAY/PAUSE button to play the disc in the programmed order.
6. To stop playing, press the STOP button.
7. To cancel the programming list, press the STOP button and open the CD door or set the
FUNCTION switch to OFF position.
Repeat Mode
Repeat 1: Press the REPAT button once, the repeat LED indicator will light and flash continuously.
This single track will be repeated.
Repeat All: Press the REPEAT button twice, the repeat LED indicator will stay lighted. The whole
disc will be played continuously.
To Cancel Repeat Function: Press the REPEAT button until the lighted repeat LED indicator turned
off.
Random Mode
Press the RANDOM button in stop mode or during play, all tracks on the disc will be played in
random order selected by the CD player.
EN 3
AUX IN Connection
1. Insert one side of the audio cable (requires 3.5mm stereo plug, not supplied) into the line-out
jack or phones jack on your audio device or MP3-Player and the other side to the aux-in jack
on the unit.
2. Turn on the unit and slide the function selector to CD/AUX position.
3. Turn on your audio device and follow the playback instruction.
4. To stop this function, simply turned off your audio device.
Important Note
Automatic standby switching
To comply with the ERP2 directive, the unit automatically switches to standby after approximately
10 minutes without a signal. To switch the unit on again, press the "PLAY/PAUSE" button on the
unit. If the PLAY/PAUSE button is pressed continuously for 5 seconds, the unit switches to standby
mode. To switch the unit on again, press the PLAY/PAUSE button on the unit.
Specifications
Frequency Range: AM: 522 -1620KHz
FM: 87.5 - 108 MHz
Power Supply: AC 230V ~ 50Hz
DC 9V
Specifications are subject to change without further notice.
SCD2000 / English Instruction Manual
(UM-2 x 6)
EN 4