Starting/Canceling; Function; Tm Baking/Roasting - Kenmore SENS-A-CLEAN 665.75842 Guía Para El Usuario

STARTING/CANCELING A FUNCTION
After setting a function, you must press START/
ENTER to start the function. If you do not
press START/ENTER within 5 seconds of
setting, "START?" will show on the
display as a reminder. If you do not press
START/ENTER within 5 minutes of setting, the time
OFF/CANCEL will cancel any function except the
Clock, Timer, or Oven/Cooktop Lockouts.
When you press OFF/CANCEL, the display
will show the time of day or, if the minute
timer is also being used, the time remaining.
of day will appear. You must reset the function and
press START/ENTER.
ULTRABAKE rMBAKING/ROASTING
Your oven _sdesigned with the tJ LTRABAKE
TM
enhanced baking system to constantly monitor
oven temperature. The bake burner will cycle, as
needed, to maintain the desired ten" 3erature. This
feature is automatica y activated when the oven is
in operation.
IMPORTANT:
• When using the oven for the first time. it is
necessary to light the surface burners first to
purge air from the gas line.
• Do not try to light the oven burner during a
power failure.
• Never place food or cookware directly on the
oven door or the oven bottom.
1.
Place the STURDIGLIDE
TM
rack(s) where you
need them in the oven. For more information, see
the "Positioning racks and pans" section, p. 10.
2. Press BAKE. PRESS YOU SEE
3. Set the temperature (optional). PRESS YOU SEE
Do this step if you want to set a temperature 1Tamp
other than 350°E Press TEMP (A) o r (y) pad(s)
to raise or lower the temperature in 5°F amounts.
Use these pads until the desired temperature
shows on the sma d sp ay.
(example for bake at 375°F)
16