Evx Pattern Size Chart; J Nozzle Options - Kasco 3.1EVX Manual Del Propietário

Note: Extra hardware may be included
STEP EIGHT
Return the unit to its upright position and select a
nozzle (See Nozzle and Pattern Options). Select the
proper Shaft Bolt (Part D2) and insert the Shaft Bolt
into the Nozzle Head so it fi ts snugly into the molded
socket. Install the Nozzle by threading it into the inner
cone of the pump. Make sure to tighten the Nozzle all
the way down.
To install the Redwood nozzle, make sure the Y Insert
(Part D4) is installed and seated properly into the
nozzle. Push the nozzle down over the cone assembly
(it may require light taps with a rubber mallet to seat
properly). Next, use the 3 Self Tapping Screws (Part
D1) provided in the 3 holes on the nozzle and tighten
the screws into the cone assembly. Once you feel
resistance, two more turns will be suffi cient. To install
the Spruce nozzle, follow the same steps, but do not
install the Y Insert.
STEP NINE
The power cord should now be attached to the stub
cord by lining up the male and female halves of the
disconnect and hand tightening the blue collar. On
these cords, the Additional Strain Relief should be
attached to one of the lower fl oat brackets as pictured.
If there is not Strain Relief, use the Nylon Cable Tie
provided to secure the cord to a rope to prevent dam-
8
age by the propeller. If installing a new Quick Dis-
connect, please refer to Quick Disconnect instructions.

EVX Pattern Size Chart

V-shaped display.
Model
3.1EVX,
3.3EVX

J Nozzle Options

NOTE: Pattern sizes listed are approximate. Varia-
tions in voltage caused by regional electrical differenc-
es or voltage drop due to long power cords may result
in reduced pattern sizes.
The Redwood nozzle uses the 3 self tapping screws to
attach over the pump housing and the Y Insert must be
installed.
Model HP
8400, 2.3 2
3.1, 3.3 3
Height Width
2.0 m 7.3 m
Height Width
5.5 m 1.5 m
6.1 m 0.9 m