Compliance With Ec Regulations - Saxxot TA1X Manual De Instalación

Ensuring proper sorted waste collection in
accordance with environmental standards,
for the disposal of further devices helps to
protect the environment and the health of
persons from any damaging effects. It also
favors the reuse and recycling of materials.
Administrative sanctions, in accordance with
regulations in effect, will be applied for any
improper or abusive disposal of the product
on part of the holder.

1.6 Compliance with EC regulations

The TAx meets the necessary requirements for
electromagnetic Compatibility
regarding electronic
European regulations:
• 2004/108/EC of 15 December 2004
• 2006/95/EC of 12 December 2006
2 M W
OUNTING TO
Install the TAx in a dry place free from any risk of
water damage. If installed outdoors, it must have
protection from the rain.
As an option the TAx can be supplied with
protection from rain and water (Protection rating
IP34).
1) Fastening screws of the protection case
Fig. 1: Protection case of the connections
To mount to wall:
Determine the position by also taking into
•
consideration the path of the connection cables
(power supply cable for TAx and cables for the
and
equipment, according
ALL
devices to be controlled). See chapter 3 for
information on connections.
Remove the protection case by unscrewing the
•
three screws indicated in Fig. 1.
Fasten the TAx via the 4 holes at the bottom, as
•
indicated in Fig. 2. Make sure the device is
fastened vertically to guarantee the proper
functioning when coins are inserted.
Proceed with the electrical connections as
•
indicated in chapter 3.
Replace the protection case as indicated in Fig.
•
1.
Security
to
1) Entrance for cables (grommets)
2) Holes for fastening to wall
3) Electronic board
4) Power supply
5) Cable clamp
Fig. 2: Mounting the TAx
3 E
LECTRICAL
WARNING: Make sure the TAx is installed
by
compliance with the regulations in effect
in the country where installation takes
place.
The cables entering the Tax through the
appropriate grommets (Fig. 2) must be
double isolation cables.
Before using the TAx, configure it by
following the appropriate manual.
Pag. 3 / 16
C
ONNECTIONS
a qualified technician
00182-M04-03-ML -
ENGLISH
and in