Forno FRHWM5029-30HB Manual De Instrucciones página 12

48" 23-9/16"
36" 17-9/16"
30" 14-9/16"
• Drill 1/8" pilot holes into the studs at the locations shown in the top view illustration.
IMPORTANT: Soffit framing must be capable of supporting up to 150lbs.
Install outlet adapter onto top of hood
IMPORTANT: Check that damper moves freely
• Place the outlet adapter (1x) over the hood exhaust and secure with 2x M4x12mm self-tapping screws
• Use duct tape to seal the connection. Check to be sure the damper moves freely.
Mount Hood onto Soffit or Cabinet
Note: If mounting to the underside of a cabinet
with a recessed bottom, install shims to fill the
gap
• Drive mounting screws into the studs until they
protrude by 1/4". The 1/4" gap will provide
clearance to engage the keyhole slots in the top
of the hood.
• Lift hood to installation position.
• Lift hood onto mounting screws. Slide back
against the rear wall.
• Tighten mounting screws.
47-15-16"
35-15/16"
29-15/16"
Back of hood
Engage top
1/4" gap
keyhole slots
Push back
to wall
Soffit
Add shims
if bottom is
recessed.
Back wall