Camo DRIVE Manual Del Propietário página 10

FASTENER INSTALLATION - EDGECLIP & EDGEXCLIP
DRIVE tool setup:
• Make sure you have a T15 DRIVE bit installed in the DRIVE tool. The T15 bit is identified with a yellow and orange color
band on the bit.
• ATTENTION! ONLY USE THE COLOR-CODED DRIVE BIT - BIT INCLUDED IN THE EDGECLIP OR
EDGEXCLIP PAILS IS FOR HAND DRIVE
• Attach the clip guide on the DRIVE tool (see changing the guide section on page 7).
• It is not necessary to load any screws into the DRIVE tool as the EdgeClips and EdgeXClips come pre-assembled.
• Drill clutch setting: If your drill has a clutch setting please start by setting the clutch to a medium low setting (30% of
maximum torque). Drive tool should drive the screw and snugly tighten down the board. If that torque setting is not
sufficient to allow the screw to be driven completely, slightly increase the torque until the the screws securely tighten the
clip in place. Excessive torque can cause over-driving resulting screw spin-out or stripping.
Board Installation:
Once your starter board is fastened in place you are ready to begin installing the rest of your deck with EdgeClip or EdgeXClip
using the DRIVE tool.
Follow the Clip installation instructions included with your EdgeClip or EdgeXClip for instruction on placing the clips in the
groove of the decking.
Once your clips are set between the deck boards, you can now use the DRIVE tool to tighten down all of the clips securing your
decking.
• Place the Clip Guide installed on your DRIVE tool over the screw
• Depress the drill trigger running at full RPM and apply downward pressure
• The Clip Guide will direct the DRIVE bit engaging the head of the screw and securing the clip in place
Visit camofasteners.com/videos for video instructions.
10