Drive; Installing The Handle - Camo DRIVE Manual Del Propietário

USING THE CAMO

INSTALLING THE HANDLE

The DRIVE ™ can be set up for left or right hand use.
The handle is attached to the tool
body screwing it onto the bolt
found installed at the top of the
tool body.
DETERMINING IF YOU WILL USE EDGE, CLIP, OR FACE FASTENING
You will need one of the two included bits and guides for your installation.
• For Edge fastening you will install a CAMO
• For Clip fastening, you will install a CAMO T-15 driver bit and the Clip guide.
• For Face (top down) fastening you will need to install the CAMO
INSTALLING THE DRIVER BITS
Use a bit to depress the release
button in the channel.
Pull the chuck back to allow the
bit to pull free and install the new
bit.

DRIVE

® ™
You can reverse the handle set up
by simply loosening the bolt and
re-installing it to the other side of
the tool body.
® T-15 driver bit and the Edge guide.
As you depress the release
button, remove the lower body
of the tool.
Replace the lower tool body – it
will click into place.
6
® T-20 bit and the Face guide.