Kenmore PG-40405S0LA Manual De Uso Y Cuidado página 23

Burner Electrode
□ Place the 5 burner electrode wires (thin black ), the ground wire (red capped) and the igniter
wire (large
difficult to install, loosen the clamp screw, put the wires through the clamp and retighten the
screw.
□ Place the 5 thin black wire into the 5 narrow slots in the electronic ignition module. Place the
red capped ground wire into the slot outlined in orange. Place the large black wire into the
wide slot. See B
□ Attach the igniter cover with (2) M4x10 screws. See C (Note: If cover is hard to install, use a
screwdriver to press down on the right door heel hook to remove the door. Install the cover,
and reattach door.) See D
M4X10 screw Qty: 2 pcs
A
C
and Igniter Cover
black) through the pre-installed side panel clamp. See A. Note: If wires are
B
D
• 23