Web Configuration - FONESTAR PDA-1408 Manual De Instrucciones

EN

WEB CONFIGURATION

To connect via LAN:
- Locate the IP address of the PDA-1408 speaker processor using the software.
- Enter the IP address of the speaker processor in your internet browser.
- Enter ID and password:
+ ID: admin
+ Default password: system
Nota: Do not change the TCP port or baudrate.
COMMUNICATION PROTOCOL RS-232 AND TCP/IP
To be connected via RS-232:
- Connect a cable to the RS-232 port on your computer. You
must connect the transmit, receive, and ground cables on the
other end of the cable to the speaker processor on the RJ-45
connector identified by RS-232 on the back of the PDA-1408
speaker processor.
- Values to be used:
+ Baud Rate: 9600
The following are the actions along with the commands you can use on this computer.
NOTE: You can find all updated commands on www.fonestar.com/EN/PDA-1408
- 12 -