Leveling Your Washer; Connecting Inlet Water - Kenmore 417.4194 Serie Instrucciones De Instalación

Installation Instructions

Leveling your washer

Excessive noise and vibration can be
prevented by properly leveling the washer.
1 For free standing
installation and with
the washer within 4
feet (1 m) of its final
location, place a
level on top of the
washer.
2 Use adjustable pliers
or the universal
wrench to adjust the
leveling legs so the
washer is level front-
to-rear and side-
to-side, and stable
corner-to-corner.
3 Press down on
alternate corners
and sides and feel
for the slightest
movement. Adjust the
appropriate leg(s) so
the washer sits solidly
on the floor on ALL four legs. Keep the
leveling leg extension at a minimum for
best performance of the washer.
NOTE
For pedestal installations, see additional
installation instructions included with the
pedestal.

Connecting inlet water

1 Run some water from the
hot and cold faucets to
flush the water lines and
remove particles that
might clog the water valve
screens and to determine
which faucet is hot and
which is cold supply.
NOTE
Hoses are not included with washer
purchase. See "Accessories" section for
various inlet hose kits to fit your specific
installation.
Rubber Washers
Must Be Present
2 Connect the
HOT inlet hose
to the HOT inlet
connection on the
washer and the
COLD inlet hose
to the COLD inlet
connection on the
washer. Tighten by
hand until snug.
Then tighten each
supply connection
another 2/3 turn
with pliers. Do not
cross thread or over-tighten these
connections.
3 Connect the HOT
inlet hose to the
HOT water supply
and the COLD
inlet hose to the
COLD water
supply. Tighten by
hand until snug.
Then tighten each
supply connection
another 2/3 turn
with pliers. Do
not bend, kink or
pinch water inlet
hoses.
4 Turn on the water and check for leaks.
10
USE ONLY
NEW HOSES