Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Installation Requirements
Tools and materials needed for installation:
OR
Adjustable
3/8" or
wrench
10 mm
box wrench
Inlet Hose (x2)
Shipping Hardware
‰ Foam shipping support (in door gas-
ket) removed and stored
‰ Shipping bolts and spacers removed
from rear of appliance and stored
‰ Hole plugs (shipped in bag in drum)
installed in holes in backsheet
Leveling
‰ Washer is level, side-to-side and
front-to-back
‰ Cabinet is setting solid on all corners
Water Supply
‰ Use only new hoses and verify rub-
ber sealing washers are installed
‰ HOT supply is connected to HOT
inlet and COLD supply is connected
to COLD inlet
‰ HOT and COLD water supply turned on
‰ No leaks present at water supply
connections or appliance inlet
connections - recheck in 24 hours
OR
Ratchet and
socket set
NOTE
Hoses are not included with washer purchase. See "Accessories" section
for various inlet hose kits to fit your specific installation.
INSTALLATION CHECKLIST
OR
AND
Optional
Adjustable
universal
wrench
Drain
‰ Stand pipe or wall drain height
minimum 24"
‰ Drain hose snapped in "U" channel
(shipped in drum)
‰ Drain hose secured in place with
cable tie (shipped in drum)
Electrical Power
‰ House power turned on
‰ Washer plugged in
Final Checks
‰ Installation Instructions and Use
and Care Guide read thoroughly
‰ Door locks and water enters drum
when cycle starts
4
AND
pliers
Carpenter's level
Publicidad
Tabla de contenido
