PREPARATION
Before beginning assembly of product, make sure all parts are present. Compare parts with
package contents list and hardware contents list. If any part is missing or damaged, do not attempt
to assemble the product.
Estimated Assembly Time: 30~60 minutes
Tools Required for Assembly (not included): Ladder, Phillips Head Screwdriver, Flathead
Screwdriver, Wire Cutters, Pliers, Safety Glasses
Helpful Tools (not included): Wire Stripper, Tape
ASSEMBLY INSTRUCTIONS
1. Unscrew canopy nut (C) from fixture assembly (B)
and detach mounting bar (A).
2. Install the mounting bar (A) to a junction box (not
included) with junction box screws (AA).
Hardware Used
Junction
AA
Box Screws
3. Make electrical connections using the wire connectors
(BB). Refer to ELECTRICAL CONNECTIONS in the
Safety Information section of page 3.
Hardware Used
BB
Wire Connector
4. Place the fixture assembly (B) against the mounting
surface, allowing the preassembled screws on the
mounting bar (A) to pass through the canopy of the
fixture assembly (B). Secure with previously removed
canopy nut (C). Adjust the track heads to desired
direction.
1
1
2
2
x 2
2 3
x 3
2 4
4
A
B
C
A
AA
BB
A
B
C