Setup - Rena Ware AQUA NANO CTU-100 Uso Y Mantenimiento

SETUP

Remove all items from shipping boxes, remove packing materials, and compare box
contents with the product diagram (Figure 1.)
1. Remove the Cover from the base assembly.
2. Install two new, high quality, AA batteries (not included) with an expiration date of
at least one year beyond the day of installation in the battery compartment located
in the Base.
3. Remove any protective plastic materials from both the NanoCeram® Cartridge
(packed in a separate box) and the Pre-Filter.
4. Install the NanoCeram® Cartridge by placing it on the Base Locking Plate (with label
facing up); turn Cartridge clockwise slightly to lock.
5. Place the Pre-Filter Cartridge, with label facing up, on top of the NanoCeram®
Cartridge; turn Cartridge clockwise slightly to lock.
8
label
label
6. Place the Inlet Assembly on top of the Pre-Filter Cartridge; rotate the Inlet Assembly
approximately 1/8 turn clockwise so that the tubing is in line with the Wand's stem.
7. Using padded or locking pliers, remove the existing aerator from your faucet.
Remove the protective wrapping from the Diverter Valve assembly.
8. Thread the Diverter Valve onto the faucet; "hand–tighten" only. Do not over tighten
as it could damage the threads. (Note: If the diverter valve is not compatible with
your faucet, contact Rena Ware Customer Service for assistance.)
9