Optional Stage Zero Filter; Operation; Care/Maintenance; Care & Maintenance - Rena Ware AQUA NANO CTU-100 Uso Y Mantenimiento

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Optional Stage Zero Filter

In areas where the amount of sediments in the water is very high,
the Pre-Filter cartridge can clog quicker than expected. The Stage
Zero external filter removes the larger particles to prevent this from
happening.
It can be easily back-flushed and replaced to allow your Aqua ✓ Nano
system to filter the very small things it was designed to remove and
let you go longer between Pre-Filter back-flushes and NanoCeram®
cartridge replacements.

OPERATION

Switch between filtered and unfiltered water using the Diverter Valve lever.
Unfiltered
When the lever is pointing down, unfiltered water will come out of your regular
faucet.
For filtered water, move the lever up 90°.
Control the temperature with your regular faucet handle.
The filter indicator will flash blue when the filter is functioning properly.
The Wand will dispense water in either a steady stream or a spray. Rotate the collar
at the end of the Wand to switch between stream and spray modes.
NOTE: For best results, after sitting overnight or after several hours of non-use, run
water through the filter for 1 MINUTE before using.
12
Filtered
12

CARE/MAINTENANCE

Cleaning the Exterior of the Aqua ✓ Nano
To clean the exterior of your faucet, filter cartridges, and base unit, use a clean,
damp cloth and mild, non-abrasive liquid soap. Do not use dishwashing soap. Rinse
thoroughly with warm water.
Note: Do not submerge the base unit or let stand in water. Excessive moisture
inside the unit will damage it and void the warranty.
Use of polish, detergents, abrasives, cleaners, organic solvents, or acid may cause
damage. USE OF OTHER THAN A DAMP SOFT CLOTH AND MILD LIQUID SOAP
WILL VOID YOUR WARRANTY.
Replacement Indicator Lights
Your Aqua ✓ Nano features a visual flow meter integrated into the base of the faucet.
When water is flowing through your filter, LED (light emitting diode) lights will flash to
indicate the following:
The blue light indicates that the unit is functioning normally.
F I LT E R I N G
The yellow warning light lets you know approximately 1,893 liters
R E O R D E R
(500 gallons) of life is left in the NanoCeram® Cartridge. Contact your Rena Ware
Consultant or Rena Ware Customer Service Center to order a replacement. The
blue
light also indicates that your filter is still working.
F I LT E R I N G
R E P L AC E
The red warning light indicates the NanoCeram® Cartridge's effective
life has ended. The blue
light will not illuminate. Replace the
F I LT E R I N G
NanoCeram® Cartridge before continuing to use your filter.
13

Publicidad

Tabla de contenido
loading

Tabla de contenido