Unpack The Pressure Washer; Add Engine Oil - Craftsman 580.752012 Instrucciones De Uso

Yourpressure w asher requires someassembly a ndis
ready for useonlyafterit hasbeenproperly serviced
withthe recommended oilandfuel,
If you haveany problemswith the assembly of
your pressure washer,pleasecall the pressure
washer
helpline at 1-800-222-3136.
UNPACK THE PRESSURE WASHER
1. Remove everything from carton except pressure
washer.
2. Open carton completely by cutting each corner
from top to bottom.
3. Remove pressure washer from carton.
CARTON CONTENTS
Check all contents. If any parts are missing or damaged,
call the pressure washer helpline at 1-800-222-3136.
• The main unit
• High pressure hose
• Spray gun
• Nozzle extension with quick connect fitting and
nozzle holder
• Engine oil
• Parts bag (which includes items listed below)
Operator's manual
Registration card
Safety goggles
Bag containing 4 multi-colored spray tips
Become familiar with each piece before assembling
the pressure washer. Compare contents against the
view on page 5. If any parts are missing or damaged,
call the pressure washer helpline at 1-800-222-3136.
ASSEMBLING YOUR PRESSURE
WASHER
Your Craftsman pressure washer was mostly assembled
at the factory. However, you will need to perform these
tasks before you can operate your pressure washer:
1. Add oil to engine crankcase.
2. Add fuel to fuel tank.
3. Connect high pressure hose to spray gun and pump.
4. Connect water supply to pump.
5. Select/attach quick connect spray tip to nozzle
extension.
Add Engine Oil
CAUTION! Any attempt to crank or start the engine
before it has been properly serviced with the
recommended oil may result in an engine failure,
1. Place pressure washer on a level surface.
2. Clean area around oil fill and remove oil dipstick.
NOTE: See the section "Oil" on page 15 to review oil
recommendations. Verify provided oil bottle is correct
vicosity for current ambient temperature.
3. Using oil funnel (optional), slowly pour entire
contents of provided oil bottle (18 oz.) into oil fill
opening.
4. Replace oil dipstick and fully tighten.
Add Fuel
All fuel is not the same. If a starting or performance
problem is encountered immediately after new fuel
has been used, try another service station or change
brands.
NOTE: This engine is certified to operate on gasoline.
Exhaust Emission Control System: EM (Engine
Modifications).
WARNING
WHEN ADDING FUEL
Turn pressure washer OFF and let it cool at least 2
minutes before removing fuel cap. Loosen cap slowly to
relieve pressure in tank.
Fill or drain fuel tank outdoors.
DO NOT overfill tank. Allow space for fuel expansion.
If fuel spills, wait until it evaporates before starting
engine.
Keep fuel away from sparks, open flames, pilot lights,
heat, and other ignition sources.
DO NOT light a cigarette or smoke.
Type of Fuel
1. Always use clean, fresh, UNLEADED gasoline
with a minimum of 87 octane/87 AKI (91 RON)
with equipment. DO NOT mix oil with fuel. DO
NOT modify the engine fuel system or carburetor
to run on alternative fuels.
NOTE: Fuel with up to 10% ethanol (gasohol) or up to
15% MTBE (methyl tertiary butyl ether), is acceptable.
IMPORTANT: Use of any fuel other than those
approved above will void warranty. Some areas require
that fuel pumps be marked if the fuel contains alcohols
or ethers. If you are not sure if your fuel contains alcohol
or ethers that are different than those approved above,
then check with the service station operator.