Assembly; Unpack Electric Pressure Washer - Craftsman CMXGWAS020727 Manual Del Operario

Assembly

Read entire operator's manual before you attempt to
assemble or operate your new electric pressure
washer.
Your electric pressure washer requires some assembly but
is quickly ready for use. If you have any problems with the
assembly of your electric pressure washer, please call the
electric pressure washer helpline at (888) 331-4569. If
calling for assistance, please have the model, revision, and
serial number from the identification label available.

Unpack Electric Pressure Washer

1. Remove everything from carton.
2. Raise handle (A) to upright position by pulling up
latch on each side of handle. Push latches (B) down
to secure handle in place.
B
A
NOTICE The unit is equipped with a foldable handle. The
handle can be folded down for storage. See Final Storage
Procedures.
3. Ensure you have all included items prior to assembly.
Items Included in the Carton
• Main unit
• Operator's manual
• Spray gun
• High pressure hose
• Spray wand with Quick Connect (QC)
• 7-in-1 nozzle
• Red high pressure nozzle
Check all contents. If any parts are missing or damaged,
call the electric pressure washer helpline at (888) 331-4569.
Become familiar with each component before assembling
the electric pressure washer. Identify contents with the
illustration shown in Features and Controls.
6
Lubricate O-Rings
Lubrication of o-rings is extremely important for
installation and operation. The use of a lubricant
(petroleum or synthetic grease) during assembly helps seat
o-rings properly and provides an improved seal. It also
helps protect the o-ring from damage by abrasion, pinching
or cutting and extends the life of the o-ring.
NOTICE ALWAYS apply a small amount of lubricant on
o-rings prior to assembling the garden hose to the pump
(C), high pressure hose (D), spray wand (E) and spray
gun (F).
Lubricate all connections shown below, following these
B
instructions:
1. Inspect and clean connecting surfaces prior to
lubrication and assembly.
2. Use lubricants sparingly during assembly; a light film
is all that is required.
3. Use a small brush or cotton swab to apply grease
directly to o-rings where they are not accessible (QC
fitting, M22 fitting).
E
F
C
D
Craftsman.com