Choice Of Location - Southwire Woods L6009 Instrucciones De Instalación

INSTALLATION

CHOICE OF LOCATION

Whenever possible, locate the unit so that its coverage area is away from heat sources, moving,
or reflective surfaces such as heating vents, air conditioners, large trees or pools of water. For
best performance, locate the unit so that motion moves across the coverage area and not directly
towards or away from the motion sensor.
Note: The detection range is based on the sensor's performance in conditions that represent
average temperatures found in North America. The detection range of the sensor will vary with
changing ambient temperatures. The motion sensor will desensitize as ambient temperature rises.
Avoid any overheating sources.
PROPER OPERATION
1. Secure the services of a qualified electrician to ensure the installation meets national and
local electrical codes.
2. DO NOT ATTEMPT TO DISASSEMBLE THE MOTION SENSOR. THERE ARE NO SERVICEABLE
PARTS INSIDE.
3. This fixture may be mounted on a wall or an eave. Controls must ALWAYS face down when
eave mounting.
4. For optimal operation and coverage area mount fixture about 8ft. above ground the on
house overhang or wall. If higher, the coverage range will be less.
5. Mount away from heat producing sources such as air conditioners and air vents or other
light sources.
6. Do not aim at highly reflective surfaces such as smooth white walls or windows.
7. Do not mount upward facing the sun.
8. Keep in mind high traffic areas, pets, heat, or other moving objects may cause
nuisance triggering.
9. Make sure to use the foam gasket and silicone during installation to ensure a watertight
installation.
10. Always point bulbs downward so water cannot enter directly!
11. The photocell recognizes darkness and ensures that the light bulbs only come on between
dusk and dawn. This feature dictates that the light bulbs do not activate during daylight
hours (accept in test mode).
MUST READ: Before installing disconnect the power to the location where the light will
be installed. Simply turning off the wall switch is not sufficient to prevent electrical shock.
The circuit breaker must be turned off.
MAIN
CIRCUIT BREAKER OR FUSE
CAUTION: BEFORE BEGINNING INSTALLATION, FIRST
DISCONNECT POWER TO WIRING LOCATION BY SHUTTING
OFF CIRCUIT BREAKER OR REMOVING FUSE AT FUSE BOX.
SHUTTING OFF A WALL SWITCH THAT CONTROLS THE LIGHT
IS NOT SUFFICIENT TO PREVENT ELECTRIC SHOCK.