Southwire Woods L6009 Instrucciones De Instalación página 5

Motion Sensor Control
TEST Mode Activates the photocell (dusk to dawn eye) and allows the motion sensor to function
in daylight hours so the fixture can be set-up
TIME Mode Turn knob from 30 seconds to 10 minutes for desired ON time after the light fixture
has been activated
RANGE Setting Mode Allows detection range to be adjusted to desired sensitivity
DOWN DETECT Expands downward detection and coverage area
LED Indicator 1. During the warm-up time the LED is on until the warm-up is complete
2. During TEST Mode, the LED is the indicator to show the user is in the detection
zone. When the sensor is triggered, the bulbs come on and the LED starts to flash.
When user is out of detection zone the LED stops flashing.
3.After the set-up is complete the LED is always on and flashing slowly to warn
intruders
Manual Override mode Turn on the wall / light switch Off-On twice within 2 seconds and the
(with wall switch) bulbs will come on and stay on. After 6 hours, this option
automatically returns to TIME Mode.
Manual override to During the light-on period (and in manual override mode) turn the wall switch
Off-On once within 1 second and the fixture will return to the TIME mode.
return to TIME mode
(with wall switch)
Temporary On Mode Turn the wall switch Off-On once within 1 second , the lights will come on to
(with wall switch) support your immediate need (light on based on "Time" setting). Time will be
reset to extend the lights on.
Temporary On Mode During the light-on period and in temporary ON mode, tum the
return to TIME mode Lamp wall switch Off-0n three times within 3 seconds
(with wall switch) option will reset sensor to the TIME Mode.
SET-UP
1. Begin in TEST mode by turning the TIME knob
to the TEST position, now the bulbs will activate in
daylight hours
2. Aim the sensor to the desired detection (target)
area. Have another person stand approximately in
the center of the target area moving arms up and
down or by walking left to right. The RED LED will
FLASH when a moving object is detected.
3. Slowly rotate the RANGE knob until the light
comes on. You may adjust the RANGE knob either
way to the desired sensitivity level (detection area).
4. Aim the unit higher for larger coverage or aim
downward for smaller spaces. This will most likely
take a couple of tries to determine your desired
trigger area. Look for the blinking RED LED to know
an object is being detected.
5. Once in the desired position tighten down the screw or ring on the motion sensor.
6. Now turn the TIME knob to adjust how long you want the lights to stay on after the
unit is activated. The maximum (full clockwise turn) is about 10 minutes. The minimum
(full counter-clockwise turn) is about 30 seconds.
SIDE VIEW FOR AIMING UNIT
8 ft.
0 ft. 17 ft. 45 ft. 70 ft.
0 ft. 17 ft. 45 ft. 70 ft.