15
16
17
18
19
20
19. BAL
The BAL control sends continuosly variable amounts of the post fader signal to either the left or right.
In the center position equal amounts of signal are sent to the left and right.
20. PFL
You can listen the signal of the only channel which PFL switch is turned "ON". So PFL routes the
channel signal to the monitoring system (Vumeter and headphones). If more than one PFL is
selected, the mixer shows the sum of them
21. MASTER FADER
60 MM fader. Its function is to adjust the volume of the whole mixed signal
22. OUTPUTS LEVEL INDICATOR
This LED´s level meter shows output level in left and right channels.
23. PHONES
This is used for monitoring the master signal or individually each channel with PFL. It incorporates
its own level control.
24. SWITCH ON/OFF
Its allows to on or off the unit. The LED lights in ON position
CLUB MASTER 1 PH
MASTER SECTION
C L U BM A S T E R1 P H
21
22
User Manual/Manual de Instrucciones
15. MIC TALKOVER
With this trimmer is possible to control de output level
if we want that the DJ MIC1 or DJ MIC2 work with
priority.
16. HIGH
Control the high frequency tone of each channel.
24
Always set this control to the 12 o´clock position,
but you can control the high frequencies tone
according to the speaker, the conditions of
listening position and listener´s taste. Clockwise
rotation of the control, increases the level.
17. MID
Control the high frequency tone of each channel.
Always set this control to the 12 o´clock position,
but you can control the mid frequencies tone
according to the speaker, the conditions of
listening position and listener´s taste. Clockwise
rotation of the control, increases the level.
18. LOW
Control the high frequency tone of each channel.
Always set this control to the 12 o´clock position,
but you can control the low frequencies tone
according to the speaker, the conditions of
listening position and listener´s taste. Clockwise
23
rotation of the control, increases the level.
Pag 4
EN