Voice Operated Transmission (Vox) Operation - Motorola PMLN6539 Manual Del Usuario

68012009041a.book Page 3 Saturday, May 11, 2013 1:59 PM
6. Release Push-To-Talk button on radio to receive
transmissions.
VOICE OPERATED TRANSMISSION
(VOX) OPERATION
1. For VOX operation, VOX must be enabled in
radio.
2. Always switch the radio OFF before connecting
the headset.
3. Attach the audio connector to the accessory audio
port on the radio.
NOTE: Once the headset has been installed the radio
speaker and the radio microphone are both
disabled. The user must speak into the headset
microphone and use the headset speaker to
listen to incoming calls.
4. Turn the radio on, adjusting the audio volume to
appropriate level.
5. Adjust the position of the headset microphone to
within 2.5 cm (1 inch) of the mouth.
6. To transmit, speaker clearly into the microphone.
The transmitter will remain keyed for a short time
after speaking. Stop speaking into the microphone
to receive transmissions.
NOTE: Do not press Push-To-Talk (PTT) button on radio
during VOX operation as it will disable the VOX
in the radio. To operate in VOX again user need
to enable VOX in radio or restart radio with
headset connected.
3