SlimPAR™ 56 QRG
Product
Description
Overview
AC Power
Power Linking
Fuse Replacement
The SlimPAR™ 56 is an LED Par that can go almost anywhere. It has 108
red, green, and blue LEDs with 3- or 7-channel DMX control.
Microphone Sensitivity
Adjustment Knob
Bracket
Adjustment
Knob
This product has an auto-ranging power supply that can work with an input
voltage range of 100–240 VAC, 50/60 Hz.
To eliminate wear and improve its lifespan, during periods of non-use
completely disconnect from power via breaker or by unplugging it.
You can link up to 50 SlimPAR™ 56 products at 120 VAC or up to 100
units at 230 VAC.
To replace the F1A, 250 V fuse in the SlimPAR™ 56:
1.
Disconnect the product from power.
2.
Wedge the tip of a flat-head screwdriver into the slot of the fuse
holder.
3.
Pry the safety cap out of the housing.
4.
Remove the blown fuse from the clip on the front of the safety cap and
replace with a fuse of the exact same type and rating.
5.
Re-insert the fuse holder and reconnect power.
Control Panel
LED Display
Back Panel View
3
EN
Fuse
Holder
Power In
Power Out