CBX MISU Manual Del Usuario página 12

Unlock the storage latch.
1
EN
Pull the stroller on the handle bar in upright position.
2
CHECK TO MAKE sure the stroller is locked in the fully open position before using it.
3-4
You hear a click sound if it is done in the right way.
To attach front wheels, push wheel onto front leg tube until it clicks into place. Repeat on other side.
5
Pull on wheels to make sure both of them are attached.
To attach rear wheels, push wheels onto rear leg tube until they click into place.
6
Pull on wheels to make sure both of them are attached.
To attach bumperbar, push bumperbar onto stroller until it clicks into place.
7
To open, pull the tab on the underside of bumperbar and rotate open or pull both tabs and lift
8
up to remove.
To attach child's tray, snap tray onto bumperbar until it clicks into place.
9
To remove, pull tabs on side of tray out from the bumperbar on the sides of child's tray and pull
10
up to remove.
NOTE: Always remove the child's tray from the bumperbar before attaching the car seat.
To lock, press lever DOWN on both brake levers.
11
To unlock, press lever UP on both rear wheels.
12
To open or close canopy, push to the front or the rear of the stroller.
13-15
To adjust legrest, pull legrest up as shown. Rotate up until it clicks into place.
16
To lower legrest, pull tube out on the edge of footrest and rotate down.
17
To recline seat, squeeze button and pull the recline strap down on the rear of seat.
18
To place seat in upright position, squeeze button and push up.
19
Recline seat to full recline position.
20
Raise legrest to full upright position.
21
12
INSTRUCTIONS