To attach the harness and waist straps to the crotch buckle, slide shoulder straps A onto the waist
22
buckles B as shown, then click them into the crotch buckle.
To unlock harness, push the button on the crotch buckle then slide the shoulder straps off the
23
waist buckles.
To adjust harness around your child, tighten shoulder and waist straps by pulling on the free end
24
of the straps as shown.
To change shoulder strap height positions, reach one hand behind the stroller and push the re-
25
tainer out to the front of seat then reinsert into the desired set of slots that are closest to your
child's shoulder.
Repeat with other harness strap.
When re-inserting the harness straps MAKE SURE to always place harness straps at the same
height setting.
Swivel wheels lock for use on rough surfaces, such as gravel or stones.
26
To lock front wheels push the lever to the RIGHT.
To unlock front wheels push lever to the LEFT.
27
Push buttons on both sides of handle and rotate into one of the 3 positions.
28
Before folding, make sure the adjustable handle is not in the lowest position.
29
Make sure the front wheels are facing forward.
Pull up on the fold strap under the pocket in the seating area as shown.
Storage latch is automatically engaged when folded.
30
Recline seat to full recline position.
31
Remove the child's tray from the bumperbar before attaching the car seat.
32
Insert car seat into stroller. Car seat will click into the car seat mounts on the sides of the stroller
33
as shown.
CHECK to make sure car seat is fully latched into the car seat mounts on each side of the stroller
34
by lifting up on it.
In order to remove the carseat from the stroller please move the red lever in direction as shown
35
by the arrow in picture. This needs to be done on both sides to remove the carseat from the
stroller.
Important — Keep these instructions for future reference.
Warnings, safety instructions, maintenance, disposal and guarantee can be found in the warnings
booklet.
INSTRUCTIONS
EN
13