Attaching Discharge Elbow - Franke CE-50 Manual De Instalación Y Servicio

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 50
EN
ELECTRICAL CONNECTION
FOR DISPOSER PROVIDED
WITH PREWIRED MOLDED
PLUG AND LEAD.
For continuous feed only
- not batch feed
3A
FIXED WIRE ELECTRICAL
CONNECTION
3B
Replacing the fuse in moulded plugs
9 The correct fuse cover must be refitted when
changing the fuse.
9 Remove the fuse cover and slide the fuse out.
9 Replace it with a 13 Amp ASTA fuse (approved
to BS 1363). Should the fuse cover be lost or
damaged, an exact replacement should be used.
These are available from an approved service
agent, listed below. Never use the plug without
the fuse cover fitted.
CE-50 / CE-75 / TE-50 / TE-75 / TE-75S / TE-125 / TE-125BF
13 AMP FUSED
DOUBLE POLE
SWITCHED SPUR
WALL MOUNTED
PLUG SOCKET
13 AMP FUSED
DOUBLE POLE
SWITCHED SPUR
WALL MOUNTED
13 AMP FUSED
SPUR MOUNTED
UNDER SINK

Attaching discharge elbow

MODELS CE-50, CE-75, TE-75S
Connect the waste elbow to the disposer by
X
X
sliding the flange against the rubber gasket on the
elbow and tightening the screws into the disposer
(fig. 4A). Then connect bottom of the elbow by
tightening the slip nut (fig. 4B). If using a straight
pipe, it must have a lip similar to the one on the
elbow. Remove the gasket from the elbow and
install it on the straight pipe with the flat end of
the gasket facing toward the disposer discharge
opening.
RUBBER
GASKET
4A
If you are connecting to a dishwasher, return to
PLUMBING CONNECTION section (2A-B). If not,
make sure all plumbing connections are tight and in
accordance with all plumbing codes and ordinances.
Run water and check for leaks.
MODELS TE-50, TE-75, TE-125, TE-125BF
Depress the wings on the spring clamp to remove
X
X
it from the rubber sleeve. Slip the spring clamp
over the smooth side of the elbow and slide it
towards the lipped side of the elbow (fig. 4C).
Insert the waste elbow into the rubber sleeve so
X
X
the elbow lip fits into the groove located inside
the rubber sleeve. Position the spring clamp over
the rubber sleeve and secure (fig. 4D). If using a
straight pipe, use one with a lip matching the lip
on the elbow supplied with the disposer.
SPRING
CLAMP
RING
4C
If you are connecting to a dishwasher, return to
X
X
PLUMBING CONNECTION section (2A-B). If not,
make sure all plumbing connections are tight
and in accordance with all plumbing codes and
ordinances. Run water and check for leaks.
– 10 –
4B
P-TRAP
4D

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Ce-75Te-50Te-75Te-75sTe-125Te-125bf

Tabla de contenido