METRO PROFESSIONAL GCV1100 Manual De Instrucciones página 13

• The actual temperature of food or beverages may
vary from the compartment temperature for a
while.
Setting the temperature
1. Press the SET button to enter the temperature
setting. The display will show the current setting.
2. Use the and
temperature.
3. Press the SET button again or wait for 10 seconds
without input to exit the temperature setting.
Switching the light on/off
• Press the ^a button to switch the light on.
• Press the ^a button again to switch the light off.
Loading the appliance
• Always let the appliance reach the set
temperature before placing food or beverages
inside the appliance. Check the cooling
temperature display and additionally reach into
the compartment with your hand to verify the
temperature.
• Always cool down food or beverages to their
intended temperature
(< 8 °C) before storing in the appliance.
• Do not place food or beverages directly onto
the shelves, use a food grade base e.g. a plate,
greaseproof paper etc.
• Distribute the food evenly with sufficient
surrounding space to ensure proper air circulation
(see illustration 17).
• Do not exceed the maximum shelf load stated in
the technical data and the stacking limit (
(see illustration 18).
• Food or beverages containing large amounts of
acid (e. g. juices, salads, vinegar, seafood, etc.)
must be packed in closed containers or vacuum
sealed.
• Ensure the doors are always properly shut and
reduce the times of open doors to a minimum.
Defrosting
Automatic defrosting
• The appliance will defrost automatically every 4
hours.
• If the ambient temperature is above 20 °C, the
scheduled defrosting will be skipped. In this case
the dot below the
seconds.
• An active defrosting process is indicated by a lit
dot in the display below the
Manual defrosting
• A manual defrosting process can be started,
when the automatic defrosting is not active.
• Press and hold the
start the manual defrosting or stop an active
defrosting process.
to select the desired
symbol will flash for a few
symbol.
button (> 6 seconds) to
• An active defrosting process is indicated by a lit
dot in the display below the
Cleaning and care
• Remove dried food remains with a plastic or
wooden spatula.
• Clean all plastic surfaces with warm, soapy water.
• Use a window cleaner for glass surfaces.
• Do not use chemical, alkaline, abrasive or other
aggressive detergents as they might be harmful to
the surfaces.
• Do not open the housing of the appliance and do
not insert any tools into the air vents.
• If the light source is damaged, it must be replaced
by the manufacturer, its service agent or similarly
qualified persons.
• This appliance does not contain any parts that
can be repaired or serviced by the consumer.
Contact a qualified specialist to have it checked
and repaired as necessary.
Troubleshooting
Suspected malfunctions, errors or damage are often
due to causes that the users can fix themselves.
Therefore check the product using below table before
contacting a qualified specialist. In most cases the
problem can be solved quickly.
WARNING!
Only perform the steps described within
this instruction manual! All further
inspection, maintenance and repair work
must be performed by an authorised
service centre or a similarly qualified
)
specialist.
Problem
1. No cooling
- 12 -
symbol.
Possible cause Solution
1.1 Not connected 1.1 Connect to
to power supply power supply
1.2 Power cord or 1.2 Check by a
plug is defective specialist
1.3 Other electrical
1.3 Check by a
defect to the
specialist
appliance
GB