Multi-Stitch Zigzag - Texi Tutu MC 9900 Manual De Operación

TEXI Tutu operation manual
3. Pass upper thread through the hole of buttonhole foot and bring
upper and bobbin threads to the left.
4. Position fabric under presser foot so that the center line mark is
in the center of the buttonhole foot. Lower the foot.
5. Reset presser bar lifter up & down for BH presser foot touch the
buttonhole lever. Now, start switch show green light.
Note: Machine will not start to sew if buttonhole lever is not
lowered properly or buttonhole foot is not positioned correctly.
6. Hold upper thread lightly and start the machine.
7. Machine will sew the buttonhole in the
order as shown and stop automatically
after sewing.
8. Raise the presser foot and cut thread. To sew over same
buttonhole, raise presser foot to return to original position.
9. Cut center of buttonhole being careful not to cut stitches
on either side. Use a pin as a stopper.
CAUTION: When using seam ripper, do not put your finger
in the path of ripper.

MULTI-STITCH ZIGZAG

A. Elastic Band Sewing
Pull elastic band in front and back of needle while sewing.
B. Overcast Stitching
Used for easy to ravel and knit fabrics. Needle should fall
on extreme edge of fabric.
Used for sewing on elastic band
and overcast stitching on knit fabrics.
133