Switching On The First Time; Operation - Franke VITAL CT2.5L Manual De Instalación Y Servicio

SWITCHING ON THE FIRST TIME

When you first use the product, in order
to remove any air inside the system, it is
recommended to:
Open the water valve and wait a
Z X
few minutes to make sure there
are no water leakage. If the system
includes electrical controls, connect
the product to the power supply to
enable the delivery keys.

OPERATION

Cold Control
It is possible to enable and disable cold
water dispensing as well as temperature
control by acting on the thermostat.
During periods with low water collection
it is better to set the thermostat at
minimum.
During periods with high water collection
it is better to set the thermostat at
maximum. In this way the cooling circuit
is able to provide an ice reserve that
would be necessary during the times of
high operation of the machine.
To modify the temperature just turn
the control handle (or the regulation
screw) following the label placed near
the thermostat. Higher values means
colder water.
Cooling Circuit Maintenance
The cooling system requires no
maintenance.
Leave a gap of at least 5 cm on each
side. This gap must be at least 25 cm by
the ventilation slots.
Press the cold water button to let the
Z X
air out. Release the button only when
the water starts coming out.
Drain a few litres of cold and warm
Z X
water.
When you first install the product,
Z X
you will have to wait approx. 1 h
before dispensing cold water.
Periodically check that the ventilation
slots are clear and not obstructed,
then remove any impurity deposited on
the ventilation slots using a brush or a
vacuum cleaner.
CAUTION: Failure to clean the
condenser and poor ventilation of the
cooling circuit can cause the compressor
to overheat and break.
Water Circuit Maintenance
Cleaning should take place at the
following times:
The first time the product is installed
Z X
(dispense some water for at least a
couple of minutes)
When parts or pieces in contact with
Z X
water are replaced
When pollution is suspected or has
Z X
occurred. This may manifest itself
as a bacterial infection with a bad
smell/taste of the water or if the
water is cloudy
Any new installation
Z X
If system has not been used for 5 days.
Z X
– 9 –
EN