LG 42LX530S Manual Del Usuario página 5

finger(s) against it for long periods of time. Doing
so may produce some temporary distortion
effects on the screen.
Preventing image burn or burn-in on
your TV screen
y If a fixed image displays on the TV screen for
a long period of time, it will be imprinted and
become a permanent disfigurement on the
screen. This is image burn or burn-in and not
covered by the warranty.
y If the aspect ratio of the TV is set to 4:3 for a long
period of time, image burn may occur on the
letterboxed area of the screen.
y Avoid displaying a fixed image on the TV screen
for a long period of time to prevent image burn.
Preparing
NOTE
y Image shown may differ from your TV.
y
y Your TV's OSD (On Screen Display) may differ
y
slightly from that shown in this manual.
y The available menus and options may differ
y
from the input source or product model that you
are using.
y New features may be added to this TV in the
y
future.
y The items supplied with your product may vary
y
depending upon the model.
y Product specifications or contents of this manual
y
may be changed without prior notice due to
upgrade of product functions.
y For an optimal connection, HDMI cables and
y
USB devices should have bezels less than 10 mm
thick and 18 mm width.
y Use an extension cable that supports USB 2.0 if
y
the USB cable or USB flash drive does not fit into
your TV's USB port.
y Use a certified cable with the HDMI logo
y
attached. If you do not use a certified HDMI
cable, the screen may not display or a
connection error may occur.
y Recommended HDMI cable types (3 m or less)
y
- High-Speed HDMI®/
- High-Speed HDMI®/
CAUTION
y Do not use any unapproved items to ensure the
y
safety and product's lifespan.
y Any damages or injuries by using unapproved
y
items are not covered by the warranty.
y Some models appear to have a thin film on the
y
screen. It is actually part of the screen; do not
remove it.
y When attaching the stand to the TV set, place
y
the screen facing down on a cushioned table or
flat surface to protect the screen from scratches.
y Make sure that the screws are fastened tightly.
y
(If they are not fastened securely enough, the TV
may tilt forward after being installed.)
y Do not tighten the screws with too much force;
y
otherwise they may be damaged and come
loose later.
cable
TM
cable with Ethernet
TM
*A 10 mm
*B 18 mm
5