Descargar Imprimir esta página

Chevrolet Performance T56 Manual Del Usario página 2

Publicidad

Idiomas disponibles

Idiomas disponibles

STARTER MOTORS:
Bellhousings are designed to be used with factory OE starters or equivalent except where noted in our catalog. Small compact high
torque mini starters will work with all Super Magnum bellhousings.
FLYWHEELS:
Bellhousings are designed for use with factory size flywheels.
IMPORTANT: Always check and confirm fitment before final installation. It is recommended to check fit the transmission
into the bellhousing before mounting it to the engine.
PREPARATION FOR INSTALLATION:
1. Place vehicle on a solid, level surface such as a garage floor to ensure safe installation.
2. Raise vehicle using appropriate lifting device and support it using automotive approved support stands having adequate load
capacity.
3. Disconnect the negative (-) cable from the battery.
CAUTION: DO NOT BEGIN THIS INSTALLATION UNTIL YOU ARE CONFIDENT THAT THE VEHICLE IS SECURE AND
SAFELY SUPPORTED!
INSTALLATION INSTRUCTIONS:
1. Remove driveshaft, starter motor, transmission and stock bellhousing.
2. Remove pressure plate and clutch disc from flywheel.
3. Remove flywheel and install blockplate. Use blockplate as is (the round hole in the blockplate will correctly locate the starter
nose assuring proper alignment). Install blockplate over the crankshaft flange and place over dowel pins in the block.
IMPORTANT: In order to comply and meet S.F.I. bellhousing specification 6.1, it is mandatory that the safety blockplate be
installed with 6.1 bellhousings and all containment fasteners supplied be used.
4. Reinstall flywheel and clutch assembly. Be sure to tighten fasteners using manufacturers recommended torque specifications.
5. Position your bellhousing over the flywheel/clutch assembly and slide onto dowel pins in engine block. Fasten the bellhousing
to the engine block using the grade 8 bolts supplied. Make sure the fasteners supplied have the same thread size/pitch as
the factory threads. Secure the blockplate to the bellhousing using the grade 8 bolts, lock washers and nuts supplied.
IMPORTANT: All fasteners must be used in their proper location for the bellhousing to meet S.F.I. specification 6.1
6. Replace starter motor, hydraulic release bearing, transmission and driveshaft.
7. Attach hydraulic clutch line and bleed system as necessary.
8. Reconnect battery
T56 Super Magnum Bell Housing Kit
19329026
IR 04SE14
PART NO.
2
6
SHEET
OF

Publicidad

loading

Este manual también es adecuado para:

193290251932962019329026