Liberty Pumps XFL Serie Manual De Instalación página 5

Power cord and control cord replacement:
The power cord and control cord are not field replaceable. If either cord is compromised the entire pump must be brought to a
qualified hazardous motor enclosure repair facility approved by Liberty Pumps. Any unauthorized field repairs voids warranty and
hazardous location ratings. Contact Liberty Pumps at 1-800-543-2550 to locate the closest repair facility.
Pump Wiring Instructions:
 Always disconnect the pump from its power source before handling.
 All electrical connections must be wired and grounded in accordance with the National Electrical Code and all applicable
local codes and ordinances.
 Risk of electrical shock – Do not remove the power supply cord. All repairs and service must be performed by a repair
facility approved by Liberty Pumps and certified to work on explosion proof motor enclosures.
 If power or control cord are damaged, or in need of replacement, contact Liberty Pumps for closest approved repair facility.
 All installations of pumps, controls, protection devices and general wiring should be done by a qualified licensed electrician.
All electrical and safety codes should be followed for the National Electrical Code (NEC), the Occupational Safety and
Health Administration (OSHA) and applicable local codes.
XFL – SERIES PUMPS
SINGLE PHASE (1PH)
NOTE: On single phase (1ph) pumps
The white and red leads of the control
cord are not used.
©Copyright 2015 Liberty Pumps Inc. All rights reserved
XFL – SERIES PUMPS
THREE PHASE (3PH)
5