Introduction; Safety - Skymsen FCZ-N Manual De Instrucciones

1. Introduction

1.1 Safety

When incorrectly used this equipment is a potentially DANGEROUS machine. Maintenance,
cleaning or any other service shall be performed by a duly trained person and with the
machine unplugged.
To avoid accidents respect the following instructions:
1.1.1 Read completely these instructions.
1.1.2 To avoid to risk electric shocks and damage to the equipment never use it with wet
clothes or shoes and/or standing on wet floors. Do not plunge it into water nor any other
liquid, do not spray water directly to the equipment.
1.1.3 When the equipment is in operation the operator shall supervise it, principally
when children might be near.
1.1.4 Place the temperature thermostat on position zero and unplug the equipment
when: It is not in use, before to clean it, before to remove or to place some accessory,
before maintenance or any other service.
1.1.5 Do not operate the equipment if the cord is damaged. Do not lean the cord on table
edges, nor let it lie on hot surfaces.
1.1.6 When the equipment may have fall , have been damaged any way, or simply does
not work, take it to Technical Assistance to check.
1.1.7 The use of accessories not recommended by the manufacturer may cause corporal
damages.
1.1.8 Keep the hands or any other object away from hot parts while the equipment is in
operation.
1.1.9 During operation, never wear loose clothes with wide sleeves principally around
the wrists.
1.1.10 Make sure the equipment voltage and the network voltage are the same, and the
equipment has been solidly grounded.
1.1.11 Never switch ON the equipment without salt oil.
1.1.12 Never touch the Resistance # 06 (Pic.01) nor the oil while they are hot or during the
cooling period because you might be burnt.
3