Install The Range - GE PGS908 Instrucciones De Instalación

INSTALL THE RANGE

INSTALL THE ANTI-TIP BRACKET
12
LOCATE THE BRACKET
A
a. Decide whether the bracket will be
installed on the right or left side of the
range opening.
b. Place the bracket as shown in Fig. 1.
Adjacent
cabinet
FLOOR-WOOD
Bracket
side
Rear
leveling leg
FLOOR-CONCRETE
Installation Instructions
Fig. 1
Wall
INSTALL THE ANTI-TIP BRACKET
12
(cont.)
INSTALL THE BRACKET IN WOOD
B
OR CONCRETE
INSTALLATION—WOOD CONSTRUCTIONS
a. Locate the centers of the 4 holes identified
in Fig. 1 as Floor–Wood and Wall.
b. Drill a 1/8" pilot hole through the
pre-marked areas. Note the angle of the
wall screw in Fig. 2.
c. Mount the Anti-Tip bracket with the
4 screws provided.
Top front
edge of
countertop
INSTALLATION—CONCRETE CONSTRUCTIONS
a. For concrete installation, you will need
two 1/4" x 1-1/2" lag screws and two sleeve
anchors.
b. Locate the center of the 4 holes identified
in Fig. 1 as Floor–Concrete and Wall.
Drill the recommended size holes in each.
c. Install the sleeve anchors into the
predrilled concrete holes and install the
lag and wall screws through the Anti-Tip
bracket. Make sure the screws are securely
tightened.
9
25"
Bracket
Wall plate
Screw
must enter
wood or
metal
Fig. 2