Memory Function - Klarstein 10032776 Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

EN
Child lock function
Im Betrieb- und im Bereischaftsmodus ist keine Kindersicherung aktiv.
Activate child lock: In the working and the standby no child lock effective state,press
and"MODE" for 3 seconds to turn on the child lock function.
Deactivate child lock: function.Under the working status and the effective state of the
standby open child lock, press
and"MODE"simultaneously for 3 seconds to turn off
the child lock function.
Remarks:
When the working state running child lock takes effect,standby operation can be
performed. Other operations are invalid(except releasing the childlock); the child lock is
canceled after standby.
When the child lock is ineffect during standby,all operations are invalid(except releasing
the child lock).

Memory function

After the machine is on standby,it will be started up again and will operate according
to the status before the last standby.Power off and power on again.It is running in
accordance with the state before the power failure.After normal standby,and then
power off,it will run at factory defaults,namely high-grade operation,set the temperature
to 35 °C by default when powering on again. After power failure,the child lock function
does no tremember.
Safety protection function
function>:When the indoor ambient temperature Th exceeds 50 °C under the standby
or working state,all out puts are turned off,the buzzer prompts 10 long beeps,the
digital screen displays"FF"and flash es at 1 Hz for 75 seconds.As long as there is
protection,even if the ambient temperature is less than 50 °C,the running or operation
can not be resumed,and the operation can only be performed after the power is turned
off and on again.
Shut down
Under the working state,press the standby key
, uon the control panel to enter the
standby state,unplug the power cord,wait for the whole machine to cool,and place the
heater stably.
Inpection method
Insert the power plug into the socket and start for use; after about half an hour, turn
off and pull out the plug. Check whether the plug pins are hot; replace the socket if
so (more than about 50 °C) to avoid burning the plug or even causing a fire caused
by overheating of the socket due to poor contact.
17

Publicidad

Tabla de contenido
loading

Tabla de contenido