Ameda One-Hand Manual Breast Pump; Set Up; Before First Use; After Every Use - Ameda Purely Yours Instrucciones

Ameda One-Hand Manual Breast Pump

Note: One-Hand Handle Assembly included with some versions. Also sold separately.

Set Up

ALWAYS WASH HANDS WELL WITH SOAP AND WATER BEFORE PUMPING.

Before First Use

If your One-Hand Manual Breast Pump is marked "STERILE," open
and use.
If your One-Hand Manual Breast Pump is NOT marked "STERILE," before
first use:
• Boil all parts for 20 minutes.
• Remove all parts from water right after boiling.
• Allow parts to air dry before assembly and use.

After Every Use

1. Take apart One- 2. Slide handle bottom
Hand Manual off breast flange.
Breast Pump.
Unscrew bottle
from breast flange.
5. Peel off piston seal 6. Pull off white valve
from piston. from breast flange.
Note: Grasp white
valve gently by
thick sides, not
by thin edge to
prevent damage.
Large plastic pieces (breast flanges, handle, and bottles) can be washed on the upper rack
of a standard household dishwasher. Wash piston, piston seal and white valve gently by hand.
Do not insert anything into white valve while cleaning.
10
E N G L I S H
3. Remove piston 4. Push down
from upper on handle to
chamber. release piston.
7. Rinse any milk 8. Allow parts to
residue from pump air dry on clean
parts with cool surface.
water.
Wash all parts
in warm, soapy
water.
Rinse well in warm,
clean water.

Assembly

Converting from Electric Pumping to Manual Pumping
1. Unsnap and 3. Fit piston seal onto
remove adapter base of piston.
cap.
2. Remove diaphragm
from upper
chamber of
breast flange.
6. Pull handle down 7. Gently push white
and snap handle valve firmly onto
collar around ring on underside
groove of of breast flange.
breast flange.
(See shaded area
in diagram above.)
4. Push center of 5. Push piston into
handle down and upper chamber
snap top of piston of breast flange.
into groove on
handle.
8. Screw breast
flange onto bottle.
Handle is on
correctly if top
of handle is a
straight line.
E N G L I S H
11