Before Use; Electrical Connection; Operation - Wilfa WSPL-3B Manual De Instrucciones

EN

BEFORE USE

ELECTRICAL CONNECTION

Check that the voltage where you shall use the unit is the same as that specified
on the unit. Details can be found on the label on the unit's base plate.
WHEN USING THE UNIT FOR THE FIRST TIME
Please run 1.25L fresh water through the unit without using a coffee filter or
coffee prior to using the unit for the first time.

OPERATION

• Place the Wilfa Performance on a flat surface. Plug the power cord into the
socket.
• Turn the on/off power switch on. Start button will blink twice and one beep
will be heard.
• Fill the water tank with fresh water to the desired amount. Place a filter paper
(1x4) in the filter holder. Place the recommended amount of coffee into the
filter.
• We recommend that you use filter ground coffee, 60 g per litre of water.
Experiment with the coffee quantities for the first few brewing's to find the
amount which you think is optimal.
• We also recommend that you use a Wilfa scale for best results.
• Attach the filter holder to the bracket. Set the flow control in relation to your
desired brew preference.
• We recommend the following ratios of water and coffee (please note that
different grinds and coffee types will influence these ratios somewhat):
1,25 l
1 l
0,75 l
0,50 l
• Press the start button to start the brewing process. Wilfa Performance has
Wilfa's unique pump system which transports water through the system at an
optimal temperature from the first to the last drop.
• When the brewing process is complete, the unit will switch over to the keep
warm state. The start button will remain lit up. After 40 minutes the coffee
maker will automatically be switched off. If you want to switch off the coffee
maker before 40 minutes (with light in start button) just press the start button
once and the coffee maker will be switched off.
INSTRUCTION MANUAL · WILFA PERFORMANCE
- 75 g
- 60 g
- 45 g
- 30 g
8