MEI EC6000 Guía De Puesta En Marcha página 3

♦
Tighten all three studs and return the discriminator back to its normal position.
Alignment Checks
Once the EC6000 has been securely fitted to the vending machine, check reject
lever operation and coin chute alignment. Do this without any power applied to
the machine.
Reject
Button
Check machine coin chute alignment by inserting
two of each coin denomination through the coin
entry slot of the machine.
Ensure that the inserted coins fall freely into the
EC6000 and exit out into the machines cash
return cup.
Cable Connection
The EC6000 is available as either MDB or Executive
with looms/cables to integrate MDB peripheral devices
or Audit devices where available.
Once all relevant cables are connected and before
closing the machine door, tuck any unused cables
away tidily ensuring that none are trapped between the
reject lever mechanism and the vending machine door.
You can now switch ON the power to the vending
machine.
Check there is a minimum 4mm gap between
Lever
the machines reject lever mechanism and the
EC6000 reject button.
4mm
Press the machine lever a couple of times and
ensure the lid of the discriminator opens and
closes correctly.
Lid
Page 3 of 10