Loading Discs - Denon DVD-1000 Instrucciones De Operación

IMPORTANT SETUP INFORMATION
This set has the following presettings: "DISC SETUP", "OSD SETUP", "VIDEO SETUP", "AUDIO SETUP", "RATING SETUP", and
"OTHER SETUP".
These presettings have been preset upon shipment from the factory. If you wish to change them to suit your specific purposes, refer to
page 32 to 43.

7 LOADING DISCS

2 Set discs in the disc tray with the labeled (printed) side facing
up.
8 cm disc guide
Disc tray
NOTE:
• Do not move the DVD-1000 while a disc is playing. Doing
so may scratch the disc.
(1) Opening and Closing the Disc Tray
q Turn on the power.
w Press the OPEN/CLOSE button.
Disc tray
NOTES:
• Be sure to turn on the power before opening and closing
the disc tray.
• Do not strike on the button with a pencil, etc.
12 cm disc guide
OPEN/CLOSE
button
(2) Loading Discs
• Pick up the disc carefully so as not to touch the signal surface
and hold it with the labeled side facing up.
• With the disc tray fully open, set the disc in the disc tray.
• Set 12 cm discs in the outer tray guide (Figure 1), 8 cm discs in
the inner tray guide (Figure 2).
• Press the OPEN/CLOSE button. The disc is automatically
loaded.
• The disc tray can also be closed automatically to load the disc
by pressing the PLAY button.
Figure 1
Figure 2
NOTES:
• If your fingers should get caught in the disc tray, stay
calm and press the OPEN/CLOSE button.
• Do not press the disc tray in by hand when the power is
off. Doing so will damage it.
• Do not place foreign objects in the disc tray. Doing so will
damage it.
ENGLISH
Outer disc tray
12 cm disc
Inner disc tray
8 cm disc
17