Troubleshooting - Elnur Gabarron BRISS Instrucciones De Instalacion Y Uso

TROUBLE SHOOTING
FAILURE POSSIBLE CAUSE
No power.
No wind It is not connected.
Some piece may be damaged.
The button ON/OFF has not been pressed
The unit can not be
Safety switch is released.
switched off.
Some piece may be damaged.
The device has abnor- Foreign objets got inside.
mal noise. The engine is damaged.
Low level or lack of water in the tank.
COOL mode (humidifier)
The inner water pipe has been droped off.
does not work.
The pump may be damaged.
The louvers do not
The engine is damaged.
oscillate
The back filter may be blocked by dust.
The air is not cold There is not enough water.
Cool air button not pressed.
STORAGE
*If you are travelling, or you are not going to use the device for a long period of time, must
be switch it off and unplug it. Remenber empty the tank as otherwise, the life of pomp and
the case will be affected.
* Clean the unit before storing it. Remove honeycomb filter, clean it and dry it off before sto-
ring it. This will prevent it from becoming smelly or moldy after it has not been used for a
long time. Cover the device with a plastic bag to prevent it from picking up dust.
* Store it in a dry and ventilated place.
SOLUTIONS
Check it is plugged into the electrical power.
PressMODE.
Take the device to technical service.
Press the ON/OFF button to switch off the unit.
Check the filter are correctly installed.
Take the device to technical service.
Remove possible objects (if any). Take the device to
technical service.
Fill the water tank.
Reconnect the water pipe.
Take the unit to the technical service.
Take the unit to the technical service.
Wash the rear filter.
Add water to the tank.
Press the COOL button.
Replace filter.