Charging Procedure - Lista MPB-20 Manual De Instrucciones

Caution: Do not touch the ground with the
chain. Ensure safety clearance of 30cm.
OPERATION
1. BEFORE PUTTING INTO OPERATION
A) CHARGING THE BATTERY
NOTE:
The battery charger supplied is matched to the
Li-ion battery installed in the machine. Do not
use another battery charger.
The Li-ion battery is protected against deep
discharging. When the battery is empty, the
machine is switched off by means of a protective
circuit: The tool holder no longer rotates.
In a warm environment or after heavy use, the
battery pack may become too hot to permit
charging. Allow time for the battery to cool down
before recharging.
When the battery pack is charged for the first
time and after prolonged storage, the battery
pack will accept a 100% charge after several
charge and discharge cycles.
B) TO REMOVE THE BATTERY PACK (SEE
FIG. C1)
Depress the Battery Pack Release Button firmly
first and then slide the Battery Pack out from
your tool.
C1
C) TO INSTALL THE BATTERY PACK (SEE
FIG. C2)
Slide the fully charged Battery Pack onto the tool
with sufficient force until it clicks into position.
C2
58
D) CHARGER (ACG18LD3/ACG1830D)
CHARGING YOUR BATTERY PACK (SEE FIG.
D1, D2)
Do not use any charger other than that
specifically provided for use with the equipment.
If the battery pack is very hot you must remove
your battery pack from the charger and allow
time for the battery to cool down before
recharging.
Please charge the battery to reach full before
storage. If the tool will not be used for long
periods of time, charge the battery every 3
months.
D1
green
light
D2

CHARGING PROCEDURE

1) Plug the charger into an appropriate outlet.
The light will be green.
2) Slide the battery pack into the charger, make
sure the battery is in the correct charge position
firmly. The light will turn to red to indicate the
charging process has started.
3) When charging is completed, the light will turn
to green.
4) After fully charged, unplug the charger and
remove the battery pack.
NOTE: If the battery pack is locked in the
charger, press the battery pack release button
and remove it.
WARNING: When battery charge runs
out after continuous use or exposure
to direct sunlight or heat, allow time for the
battery to cool down before re-charging to
achieve the full charge.
red
light