Goldstar WG8005R Manual Del Propietário página 15

Installation
_k aution: During the following step, hold unit firmly until window sash
is lowered to top channel behind side panel frames. Personal injury or
property damage may result if unit falls from window.
1. Open the window. Mark a line on
center of the window stool(or desired
air conditioner location).
Carefully place the cabinet on the
window stool and align the center
mark on the bottom front with the
center line marked in the window
stool.
2. Pull the bottom window sash down
behind the upper guide until it meets.
:Do not pull the window sash
down so tightly that the movement of
Frame Curtain is restricted.
3. Loosely assemble the sill support
using the parts in Figure 3.
4. Select the position that will place the
sill support near the outer most point
on sill (See Figure 4)
• Be careful when you install
the cabinet (Frame Guides will be
broken easily).
5. Attach the sill support to the cabinet
track hole in relation to the selected
position using 2 Type A screws in
each support(See Figure 4).
6. The cabinet should be installed with a
very slight tilt(about V2") downward
toward the outside (See Figure 5).
Adjust the bolt and the nut of sill
support for balancing the cabinet.
7. Attach the cabinet to the window stool
by driving the screws (Type B:Length
sixteen millimeters and below.) through
the front angle into window stool.
8. Pull each Frame curtain fully to each
window sash track, and repeat step 2.
Upper G uid_in dOF_O_ie 1
Window Sash Upper Guide
Foam-Pe
Cabinet/ "_"_ __"_._ Iltl
Frame Curtain 1111 _i__
Foam-Pe _
Figure 2
INDOOR _-------, r ,OUTDOOR I
- - I
Sill Support
Bolt ...... Nut
F gure 3
Frame Guide
Screw(Type A)
"///7//////4 OUTDOOR Figure
Screw(Type B)
Sill Support
Sill Support
;i[;i
.z- SashTrack
_ FrontAngle
\
Screw(Type B)
Figure 5
Owner's Manual 15