Goldstar WG8005R Manual Del Propietário página 19

Operating Instructions
_k AUTION: The Remote Controller will not function properly if strong
light strikes the sensor window of the air conditioner or if there are
obstacles between the Remote Controller and the air conditioner.
Power
• To turn the Set ON, push the button. To turn the Set OFF, push the button again.
• This button takes priority over any other buttons.
• When you first turn it on, the set is on the High cool mode and the temp. at 72°F
Temperature Setting
• This button control the room temperature setting in a range
between 60°F to 86°F in 1°F increments.
Fan Speed
• Pressing the Fan Speed button toggles between Lowand High
speeds.
On/Off Timer
- Stopping Operation
• Each press of the button cycles through the options in this
order:
1Hour_ 2Hours_ 3Hours_ 4Hours_ 5Hours_ 6Hours_ ,.
7Hours_ 8Hours_ 9Hours _10Hours _ 11Hours_ 12Hours_ CANCLE.
• The set temperature will be raised by 2°F after 30 minutes and
again after another 30 minutes.
- Starting Operation
• Each press of the button cycles through the options in this
order:
1Hour_ 2Hours_ 3Hours_ 4Hours_ 5Hours_ 6Hours
7Hours_ 8Hours_9Hours _ 10Hours _ 11Hours_ 12Hours _ CANCLE.
Energy Saver
The fan stops when the compressor stops cooling.
• Approximately every 3 minutes the fan will turn on and
check the room air to determine if cooling is needed.
Cool/Fan/Dry
• Everytime you push this button, it will toggle between COOL, FAN, and DRY.
Fan Speed
Timer Mode
Energy
Saver
How to Insert Batteries
1. Remove the cover from the back of the remote
controller
2. Insert two batteries.
• Be sure of the polarity when installing the
batteries.
• Be sure that both batteries are new.
3. Re-attach the cover.
®
• Do not use rechargeable
batteries. Such batteries
differ from standard dry cells
in shape, dimensions, and
performance.
• Remove the batteries from
the remote controller if the air
conditioner is not going to be
used for an extended length
of time.
Owner's Manual 19