PocketWizard PLUS III Guia De Inicio Rapido página 8

Auto-Relay
NOTE: Auto-Relay allows you to trigger remote flashes in sync with a remote camera and
requires only three PocketWizard
all PocketWizard radios are set to the same channel: The relaying radio trasmits on one
channel higher than it received on. Visit wiki.PocketWizard.com for additional information.
Plus III
®
(Transmitting)
Channel 1 Receiving Ch.1 & Transmitting Ch.2
Using Auto-Relay
1. Set the transmitting PocketWizard radio in your hands to TxRx Mode and
the desired channel and zone.
2. Connect the relaying Plus III's Flash/Camera Port to the remote camera
triggering port of the camera via a remote camera cable and place the
radio in the camera's hot shoe.
3. Set the relaying Plus III attached to your remote camera to TxRx Mode and also to
the same channel and zone as the transmitting PocketWizard radio in your hands.
4. Connect a remote flash to a receiving PocketWizard radio via the appropri-
ate sync cable and set it to TxRx Mode and one channel higher than the
transmitting PocketWizard radio in your hands.
5. Press and release TEST on the transmitting PocketWizard to fire the remote
camera. Remote flashes will be automatically synchronized with the camera.
radios. Using Auto-Relay is the only situation where not
®
Remote Camera
(Relaying Plus III)
Remote Flash
(Receiving)
Channel 2