Frigomat T4s Serie Manual De Uso Y Mantenimiento página 62

6.3.5 SLUSH PROGRAM WITH CONSISTENCY CONTROL
Fig.1
Fig.2
Fig.3
Fig.4
Fig.5
23 - ENGLISH
- Press the SLUSH key (fig.1).
- The LEDs of the UP, Confirm and DOWN keys
light up and the GR1 message is viewed on the
display, which distinguishes the slush production
program with consistency control and continuous
mixing (fig. 2-3).
- Press the CONFIRM key to accept the selection of
program GR1.
- The LEDs of the UP, Confirm and DOWN keys
light up and the numbers relative to the
consistency setting to be configured appear on the
display, expressed by a numerical value between
120 and 180: press the UP and DOWN keys to
increase or decrease
consistencies correspond to high numbers, lower
consistencies correspond to low numbers (fig.4).
The maximum programmable consistency value is
equal to 180 numbers but not all mixtures and not all
quantities can reach such a high consistency value.
For a reduced amount of mixture it is recommended
to not select consistency numbers close to 180.
- Subsequently, press the Confirm key to start a
new slush production cycle (fig. 5).
- After a few minutes and once the consistency
level selected during the programming phase has
been reached, an intermittent acoustic signal
warns the operator that it is possible to extract the
product. If this should not be immediately possible,
the machine will automatically see to maintain the
product over time without changing its consistency
any further.
- It is possible to go to the product extraction phase
at any time.
the value. Higher